tested Interface for Supervision (from Värmepump Diplomat)

[Gäst]

see here

www.freewebs.com/libisainen

[Per-Erik]

It seems that it is the same Cabel/interface as they use to the heat-Pump Diplomat..

That interface + Thermia supervision software..

Cost = under 1000:- Sek.


Some one know were to find the Software? my copy is gone to heaven! (my HD died on me)

[Barsk]

Anybody knows if the Biomatic 20+ boiler has the same interface as the Bequeem burner?
I.e can I attach the cable to the circuit board in the boiler?

[Gäst]

Yes, it´s the same connector!

[Per-Erik]

now i got the software.. "only" the interface left for me to get hold of..

[pellman]

The "interface" should not be hard to build yourself. I assume it is RS232 to RS485 or something like that. Anyone have any info?

[Gäst]

There is a pic with program in the interface. amost impossible to make by yourself...

[pellman]

OK it´s better to buy...

[byggom]

vart beställer interfacet ifrån?
Helt klart intressant när man skall bort nu i sommar.

[Gäst]

contact the heatpump-division of thermia in arvika

[per pellet]

try

roland.lund@thermiapellets.se
fax 570 17575 att. roland lund

Unfortunately:

Your message
Subject: "Interface 518"
could not be delivered to some or all of the intended recipients.
User<roland.lund@thermiapellets.se> - (550 5.1.1 User unknown)

[per pellet]

And further:

The following recipient(s) could not be reached:
info@thermiapellets.se on 2006-05-09 09:54
The e-mail account does not exist at the organization this message was sent to.
Check the e-mail address, or contact the recipient directly to find out the correct address.
<web-is-s104.web2000.activeisp.com #5.1.1 smtp;550 5.1.1 <info@thermiapellets.se> is not a valid mailbox>

[Gäst]

Thermia Värme AB
article number 5206-54176001
fax +46 570 17575

[byggom]

De svarade att Thermia pelletssystem inte säljer separata interface utan bara en komplett lösning. Men man kunde kontakta Thermia värme.

[zeylon]

I think Thermia might have contacted libi and complained since he has deleted all his posts in this thread.